|
Quadro Profile System frames assemble in seconds with no tooling required.
Frame Assembly
1. Install Corner Clips onto Mouldings : Install the 4 corner clips onto the mouldings as shown…
- Note bumps/nibs on corner clip. These are intended to snap into the oval hole on the moulding.
- Corner clips slide into the BACK channel of the mouldings.
- Push corner clip into the channel all the way – nib will snap into oval cutout. To remove clip gently lift the tab at the end so the nib clears the oval cutout and slide clip out.
- Install the clips on 1 length of moulding only (either the short or the long but not 1 on each)
2. Assemble Frame & Mouldings : Assemble the framing system…
- Insert image between glazing and backing.
- Slip a moulding with corner clips over the edge.
- Slide the two mouldings without corner clips over the edges and snap into the corner clips on the installed moulding.
- Slip the second moulding with corner clips over the edge and snap together to close & secure.
Wall Hanging
1. Wall Hanging from Snap-in Hanger, for smaller frames.
- Moulded Hanger/Easel is supplied with smaller frames. Note peg on moulded hanger. Peg fits into one of holes on back panel (for horizontal or vertical display). Snap top of hanger into the adjacent moulding and then push peg into hole.
2. Wall Hanging from Corner Clips, for all frame sizes.
- Frames can also be hung from corner clips (without central hanger). Note sawtooth pattern on corner clips – this allows for levelling while hanging. For corner clip hanging 2 nails will be required.
Tabletop Display
1. Frames up to 11x14" in size can be table-top displayed with the supplied dual purpose hanger/easel.
- Moulded Hanger/Easel is supplied with smaller frames. Note slotted opening at lower corner. The slot snaps into the back of the molding system to support the frame for tabletop display as illustrated.
|
